A K C E C A S H B A C K J E Z P Ě T
VIP audio
Reprosoustavy
Kabely
Konektory
Síťová filtrace
Servery & Rippery | Switche
Multi Room systémy
Distribuce AV signálu
Distribuce IR signálu / D.O.
AV nábytek
LP / CD / SACD
Příslušenství
U nás k poslechu
Vestavné reproduktory Q Acoustics Qi65CP
- Doprava ZDARMA
- Kompletní specifikace
- Hodnocení 0
- Komentáře 0
- Ke stažení
- Vestavné reproduktory Q Acoustics Qi65CPskladem u dodavatele, expedice do 24 hodin8 500,00 Kč7 024,79 Kč bez DPH
Vestavné reproduktory Q Acoustics Qi65CP
165 mm koaxiální stropní repro, kulatá mřížka
Stropní reprosoustavy od Q Acoustics se nabízí ve trojím provedení: v sérii Profesional, Performance a Weatherproof. Profesional má hedvábnoumembránu výškového reproduktoru, Performance má titanovou. Série Weatherproof je určena do vlhkých prostor jako jsou koupelny, bazényapod. Všechny série se nabízí v klasickém provedení reproduktoru a také v provedení single stereo.
Technická specifikace:
How to guide
Step 1
Select a suitable mounting location for the speaker taking note of the Warning Notices above. Using the installation template supplied mark the speaker position and cut the mounting hole.
Step 2
Make sure all equipment is switched off. The speaker cable should be stripped back ~10mm so that there are bare wire ends. Remove the packaging and protective dust cover from speaker and attach the speaker leads using the pushdown spring clip terminals at the rear of the speaker. The positive conductor should be connected to the red terminal and the negative conductor to the black terminal. For single stereo versions there are two sets of terminals for connection of left and right channels.
Note: Tweeter output level adjustment (‘P’ & ‘CW’ versions)
It is recommended to leave the switch in the ‘0’ position for the initial sound check.
Step 3
Check that each of the 4 swing out clamps are rotated inwards. Push the speaker through the mounting hole and position flush with the ceiling. Whilst holding the speaker in place tighten each of the mounting screws using a No. 2 Pozidriv® screw driver in the order shown in the diagram (left). When an increase in resistance is felt the clamp is in position.
Step 4
Once the speakers are installed they should be tested before the grilles are fitted. The tweeter’s outer frame (not dome) should be pushed gently to achieve the desired tweeter position.
Step 5
The 6.5” Professional in-ceiling single stereo speaker features a magnetic grille, locate the grille over the speaker bezel where it will be pulled into place. Note that square grilles may be positioned at any angle required.
Some models feature a white backing cloth behind the grille to help minimize visual contrast with the ceiling. For the very best sound performance it is recommended that this cloth is removed before use. To remove simply peel away the backing cloth from the grille.
Q Acoustics Qi65CP, QI65CP, QI65 CP, QI65-CP, QI-65CP, QI 65 CP, QI-65-CP
